Próba szerencse alapon megpróbáltam terminálból kiírni a fentiek alapján. Ez sem ment... Itt a kimenet:
robiwolf@desktopmachine:~$ cdrecord -v dev=/dev/sr0 /home/robiwolf/ubuntu-9.10-desktop-i386.iso
wodim: No write mode specified.
wodim: Asuming -tao mode.
wodim: Future versions of wodim may have different drive dependent defaults.
TOC Type: 1 = CD-ROM
wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.scsidev: '/dev/sr0'
devname: '/dev/sr0'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.6
SCSI buffer size: 64512
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identification : 'DVD-RAM GSA-H55N'
Revision : '1.03'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0014 (DVD-RW sequential recording)
Profile: 0x0012 (DVD-RAM)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording) (current)
Profile: 0x0013 (DVD-RW restricted overwrite) (current)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Using generic SCSI-3/mmc DVD-R(W) driver (mmc_mdvd).
Driver flags : SWABAUDIO BURNFREE
Supported modes: PACKET SAO
Drive buf size : 1409024 = 1376 KB
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
Drive DMA Speed: 84884 kB/s 482x CD 61x DVD
FIFO size : 12582912 = 12288 KB
Track 01: data 689 MB
Total size: 792 MB (78:30.21) = 353266 sectors
Lout start: 792 MB (78:32/16) = 353266 sectors
Current Secsize: 2048
HINT: use dvd+rw-mediainfo from dvd+rw-tools for information extraction.
Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 1945230
Speed set to 5540 KB/s
Starting to write CD/DVD at speed 4.0 in real unknown mode for single session.
Last chance to quit, starting real write i 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Starting new track at sector: 0
Track 01: 0 of 689 MB written.Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB: 2A 00 00 00 00 00 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 72 0B 00 00 00 00 00 0E 09 0C 00 00 00 02 00 00
Sense Key: 0x0 No Additional Sense, Segment 11
Sense Code: 0x00 Qual 0x02 (end-of-partition/medium detected) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 42.586s timeout 40s
write track data: error after 0 bytes
wodim: A write error occured.
wodim: Please properly read the error message above.
Writing time: 90.853s
Average write speed 11.0x.
Fixating...
Fixating time: 0.003s
wodim: fifo had 192 puts and 1 gets.
wodim: fifo was 0 times empty and 0 times full, min fill was 100%.
robiwolf@desktopmachine:~$
Be kell vallanom, ilyennel még nem találkoztam... Mondjuk eddig Poweriso-val írtam ki mindent wine-on keresztül, semmi probléma nem volt, de már szégyeltem... Most azzal is megpróbáltam, fel sem ismeri a DVDírót.