B2manAmi késik, nem múlik. :)
Félkövér sorok a fontosak
sudo pwmconfig
# pwmconfig revision 5857 (2010-08-22)
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.
We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.
Found the following devices:
hwmon0/device is nouveau
hwmon1/device is w83697hf
Found the following PWM controls:
hwmon1/device/pwm1
hwmon1/device/pwm2
Giving the fans some time to reach full speed...
Found the following fan sensors:
hwmon1/device/fan1_input current speed: 0 ... skipping!
hwmon1/device/fan2_input current speed: 4623 RPM
Warning!!! This program will stop your fans, one at a time,
for approximately 5 seconds each!!!
This may cause your processor temperature to rise!!!
If you do not want to do this hit control-C now!!!
Hit return to continue: # Enter
Testing pwm control hwmon1/device/pwm1 ...
hwmon1/device/fan2_input ... speed was 4623 now 4623
no correlation
No correlations were detected.
There is either no fan connected to the output of hwmon1/device/pwm1,
or the connected fan has no rpm-signal connected to one of
the tested fan sensors. (Note: not all motherboards have
the pwm outputs connected to the fan connectors,
check out the hardware database on http://www.almico.com/forumindex.php)
Did you see/hear a fan stopping during the above test (n)? y
Testing pwm control hwmon1/device/pwm2 ...
hwmon1/device/fan2_input ... speed was 4623 now 4623
no correlation
No correlations were detected.
There is either no fan connected to the output of hwmon1/device/pwm2,
or the connected fan has no rpm-signal connected to one of
the tested fan sensors. (Note: not all motherboards have
the pwm outputs connected to the fan connectors,
check out the hardware database on http://www.almico.com/forumindex.php)
Did you see/hear a fan stopping during the above test (n)? y
Testing is complete.
Please verify that all fans have returned to their normal speed.
The fancontrol script can automatically respond to temperature changes
of your system by changing fanspeeds.
Do you want to set up its configuration file now (y)? y
What should be the path to your fancontrol config file (/etc/fancontrol)? # Enter
Loading configuration from /etc/fancontrol ...
Select fan output to configure, or other action:
1) hwmon1/device/pwm2 3) Change INTERVAL 5) Save and quit
2) hwmon1/device/pwm1 4) Just quit 6) Show configuration
select (1-n): 5
Saving configuration to /etc/fancontrol...
Configuration saved
De a végén kiválaszthatod, azaz konfigurálhatod az '1'-et, a '2'-t, kis gond, hogy mindez nem mentődik el az '/etc/fancontrol'-hoz (nálam). Igazság szerint és 'gksu terminator'-ral (is!) csináltam és sudo nélkül, még úgy sem.
Amire támaszkodtam
https://iandw.net/2014/10/12/fancontrol-under-ubuntu-14-04-resolving-usrsbinpwmconfig-there-are-no-pwm-capable-sensor-modules-installed/